Use Traffic Management with Application Control

You can use Application Control with Traffic Management to control bandwidth used by applications or application categories. When you use Traffic Management in Application Control, the application traffic is allowed, but is subject to the bandwidth settings in the Traffic Management action. If you apply a Traffic Management action to an application category, the bandwidth settings are shared for all applications in the category.

Traffic Management Actions in Application Control apply to application traffic in both directions for all policies that use the Traffic Management Action.

The way that Traffic Management Actions apply to application traffic depends on the type of Traffic Management Action.

All Policies

If you use an All Policies Traffic Management Action for an application or application category, the bandwidth settings apply to the combined Forward and Reverse application traffic for all policies that use it. If applied to an application category, the Traffic Management Action applies to the total bandwidth used by all applications in the category for all policies.

Per Policy

If you use a Per Policy Traffic Management Action for an application or application category, the bandwidth settings apply to the combined Forward and Reverse application traffic for each policy that uses it. If applied to an application category, the Traffic Management Action applies to the total bandwidth used by all applications in the category for each policy.

Per IP Address

If you use a Per IP Address Traffic Management Action for an application or application category, the bandwidth settings apply to the combined Forward and Reverse application traffic for each IP address that uses the application. If applied to an application category, the Traffic Management Action applies to the total bandwidth used by each IP address for all applications in the category for all policies.

To use Traffic Management Actions in Application Control, the device must use Fireware XTM v11.9 or higher.

Before you can use Traffic Management with Application Control, you must first create the Traffic Management Action. For more information, see Define a Traffic Management Action in v11.9.

To use a Traffic Management Action for an application:

  1. Create or edit an Application Control Action. For more information, see Configure Application Control Actions.
  2. Select the application you want to control.
  3. Click Edit.

Screen shot of the Actions by Application dialog box with Traffic Management configured

  1. Set the action for all behaviors or specific behaviors to Allow.
  2. Select the Traffic Management check box.
  3. Frpm the adjacent drop-down list, select the Traffic Management action to use for allowed traffic for this application.

To use a Traffic Management Action for an application category:

  1. Create or edit an Application Control Action. For more information, see Define a Traffic Management Action in v11.9.
  2. On the Application Control Action Settings page, click Select by Categories.
    The Actions by Category dialog box appears.

Screen shot of the Actions by Category dialog box with Streaming Media set to use a Traffic Management action

  1. From the drop-down list for the application category, select the Traffic Management Action to use for this application category.

After you enable configure an Application Control Action to use Traffic Management, make sure that you enable policies that handle traffic for the applications to use the Application Control Action. For more information, see Configure Application Control for Policies.

See Also

About Traffic Management in Fireware XTM v11.9 and Higher

Give Us Feedback  •   Get Support  •   All Product Documentation  •   Knowledge Base