Enable SNMP Polling

You can configure your Firebox or XTM device to accept SNMP polls from an SNMP server. Your device reports information to the SNMP server such as the traffic count from each interface, device uptime, the number of TCP packets received and sent, and when each network interface was last modified.

  1. Select System > SNMP.
    The SNMP page appears.

Screen shot of the SNMP Settings page

  1. To enable SNMP, from the Version drop-down list, select an option:
  1. To enable NAT for all SNMP connections through your Firebox or XTM device, select the Use NAT for connections through the SNMP application layer gateway check box.
  2. Click Save.

To enable your Firebox or XTM device to receive SNMP polls, you must also add an SNMP packet filter policy.

  1. Select Firewall > Firewall Policies.
  2. Click Add Policy.
  3. From the Packet Filters drop-down list, select SNMP. Click Add Policy.
    The Policy Configuration page appears.
  4. In the From section, click Add.
    The Add Member dialog box appears.
  5. From the Member type drop-down list, select Host IP.
  6. In the Member type text box, type the IP address of your SNMP server. Click OK.
    The IP address of the SNMP server appears in the From list.
  7. From the From list, select Any-Trusted. Click Remove.
  8. In the To section, click Add.
    The Add Member dialog box appears.
  9. From the drop-down list, select Firebox. Click OK.
    Firebox appears in the To list.
  10. From the To list, select Any-External. Click Remove.
  11. Click Save.

See Also

About SNMP

About Management Information Bases (MIBs)

Enable SNMP Management Stations and Traps

Give Us Feedback  •   Get Support  •   All Product Documentation  •   Knowledge Base